ETAP 30

ETAP 30
Development
DesignerJacques de Ridder
LocationBelgium
Year1985
No. built220
Builder(s)ETAP Yachting
RoleCruiser
NameETAP 30
Boat
Displacement7,940 lb (3,602 kg)
Draft5.90 ft (1.80 m) with the keel down
Hull
Typemonohull
Constructionglassfibre
LOA29.60 ft (9.02 m)
LWL25.08 ft (7.64 m)
Beam10.33 ft (3.15 m)
Engine typeVolvo 2002 18 hp (13 kW) diesel engine
Hull appendages
Keel/board typefin keel
Ballast3,032 lb (1,375 kg)
Rudder(s)internally-mounted spade-type rudder
Rig
Rig typeBermuda rig
I foretriangle height33.30 ft (10.15 m)
J foretriangle base11.00 ft (3.35 m)
P mainsail luff36.60 ft (11.16 m)
E mainsail foot12.00 ft (3.66 m)
Sails
Sailplanfractional rigged sloop
Mainsail area259 sq ft (24.1 m2)
Jib/genoa area289 sq ft (26.8 m2)
Spinnaker area593 sq ft (55.1 m2)
Upwind sail area549 sq ft (51.0 m2)
Downwind sail area852 sq ft (79.2 m2)

The ETAP 30 is a Belgian sailboat that was designed by Jacques de Ridder as a cruiser and first built in 1994.[1][2][3][4][5]

Production

[edit]

The design was built by ETAP Yachting in Belgium between 1985 and 1994, with 220 boats completed, but it is now out of production.[1][2][3][6][7]

Design

[edit]

The ETAP 30 is a recreational keelboat, built predominantly of polyester glassfibre-foam sandwich construction, with wood trim. The use of foam sandwich construction makes the boat unsinkable. It has a 7/8 fractional sloop masthead sloop rig with aluminum spars, a deck-stepped mast, wire standing rigging and a single set of swept spreaders. The hull has a raked stem, a reverse transom, an internally-mounted spade-type rudder controlled by a tiller and a fin keel or optional shoal draft keel. It displaces 7,940 lb (3,602 kg) and carries 3,032 lb (1,375 kg) of cast iron ballast.[1][2]

The boat has a draft of 5.90 ft (1.80 m) with the standard keel and 4.25 ft (1.30 m) with the optional shoal draft keel.[1][2][3]

The boat is fitted with a Volvo 2002 18 hp (13 kW) diesel engine for docking and manoeuvring. The fuel tank has a capacity of 11 U.S. gallons (42 L; 9.2 imp gal).[1][2][3]

The design has sleeping accommodation for five people, with a double "V"-berth in the bow cabin, two straight settees in the main cabin, plus an aft berth on starboard side. The galley is located on the port side just forward of the companionway ladder. The L-shaped galley is equipped with a two-burner stove, an 11.4 U.S. gallons (43 L; 9.5 imp gal) capacity icebox and a sink. The head is located just aft of the bow cabin. The fresh water tank has a capacity of 21 U.S. gallons (79 L; 17 imp gal).[1][2][3]

For sailing downwind the design may be equipped with a symmetrical spinnaker of 593 sq ft (55.1 m2). It has a hull speed of 6.81 kn (12.61 km/h).[2][3]

Operational history

[edit]

The boat was at one time supported by a class club, the ETAP Owners Association.[8]

A 2009 Yachting Monthly review stated, "In many people's view, this was the best yacht Etap produced – and although she lacks an aft cabin, she was far ahead of her time in many other respects, not least her easily-driven hull, designed by Jac de Ridder, which was streets ahead of most other 30ft cruisers when she was launched, in 1983. She handles delightfully on all points of sail and is still a fairly fast cruiser for her length by today’s standards. The hull’s high freeboard is effectively masked by a thick gunwale stripe and the low-profile cabin top gives her an almost racy appearance. Down below she has five sea-berths (or six at anchor), including a quarterberth, and a heads compartment amidships. The galley is spacious and seamanlike, and she has a very practical chart table. Etap's tendency towards short coachroofs means that headroom in the heads and forecabin is restricted but it is fair in other parts of the boat The standard of fit-out is good, with solid teak trim, but stowage, as always with these double-skinned yachts, is limited."[9]

See also

[edit]

References

[edit]
  1. ^ a b c d e f McArthur, Bruce (2020). "ETAP 30 sailboat". sailboatdata.com. Archived from the original on 29 March 2021. Retrieved 29 March 2021.
  2. ^ a b c d e f g "Etap 30 Deep draft". Boat-Specs.com. 2020. Archived from the original on 29 March 2021. Retrieved 29 March 2021.
  3. ^ a b c d e f "Etap 30 Shoal draft". Boat-Specs.com. 2020. Archived from the original on 29 March 2021. Retrieved 29 March 2021.
  4. ^ McArthur, Bruce (2021). "Jacques de Ridder". sailboatdata.com. Archived from the original on 16 January 2021. Retrieved 29 March 2021.
  5. ^ "Jac de Ridder Yacht Design". Boat-Specs.com. 15 March 2020. Archived from the original on 27 March 2021. Retrieved 29 March 2021.
  6. ^ McArthur, Bruce (2021). "Etap Yachting". sailboatdata.com. Archived from the original on 23 March 2021. Retrieved 29 March 2021.
  7. ^ "Etap". Boat-Specs.com. 2020. Archived from the original on 26 March 2021. Retrieved 29 March 2021.
  8. ^ McArthur, Bruce (2021). "Etap Owners Association". sailboatdata.com. Archived from the original on 23 March 2021. Retrieved 29 March 2021.
  9. ^ "ETAP 30". Yachting Monthly. 5 August 2009. Archived from the original on 26 October 2020. Retrieved 29 March 2021.
[edit]