Ranger 24

Ranger 24
Development
DesignerRaymond H. Richards
LocationUnited States
Year1974
Builder(s)Ranger Fiberglass Boats
RoleRacer-Cruiser
NameRanger 24
Boat
Displacement3,140 lb (1,424 kg)
Draft4.00 ft (1.22 m)
Hull
Typemonohull
Constructionfiberglass
LOA23.92 ft (7.29 m)
LWL20.00 ft (6.10 m)
Beam8.33 ft (2.54 m)
Engine typeoutboard motor
Hull appendages
Keel/board typefin keel
Ballast1,400 lb (635 kg)
Rudder(s)transom-mounted rudder
Rig
Rig typeBermuda rig
I foretriangle height29.00 ft (8.84 m)
J foretriangle base10.00 ft (3.05 m)
P mainsail luff25.00 ft (7.62 m)
E mainsail foot7.50 ft (2.29 m)
Sails
Sailplanmasthead sloop
Mainsail area93.75 sq ft (8.710 m2)
Jib/genoa area145.00 sq ft (13.471 m2)
Total sail area238.75 sq ft (22.181 m2)
Racing
PHRF216

The Ranger 24 is an American trailerable sailboat that was designed by Raymond H. Richards as an International Offshore Rule Quarter Ton class racer-cruiser and first built in 1974.[1][2][3]

Production

[edit]

The design was built by Ranger Fiberglass Boats in Kent, Washington, United States (not to be confused with Ranger Yachts), starting in 1974, but it is now out of production.[1][3]

Design

[edit]

The Ranger 24 is a recreational keelboat, built predominantly of fiberglass, with wood trim. The hull has a single hard chine and positive flotation, making the boat unsinkable. It has a masthead sloop rig, a raked stem, a plumb transom, a transom-hung rudder controlled by a tiller and a fixed swept fin keel. It displaces 3,150 lb (1,429 kg) and carries 1,400 lb (635 kg) of lead ballast.[1][3]

The boat has a draft of 4.00 ft (1.22 m) with the standard keel.[1][3]

The boat is normally fitted with a small 3 to 6 hp (2 to 4 kW) outboard motor mounted in centerline well, for docking and maneuvering.[1][3]

The design has sleeping accommodation for four people. The galley is located on the port side just forward of the companionway ladder. The galley may be optionally equipped with a gimballed stove and oven, and a refrigerator. Cabin headroom is 67 in (170 cm).[1][3]

For sailing the design is may be equipped with one of a series of jibs or genoas.[3]

The design has a PHRF racing average handicap of 216 and a hull speed of 5.0 kn (9.3 km/h).[3]

Operational history

[edit]

In a 2010 review Steve Henkel wrote, "designer Ray Richards of Seattle drew this quarter ton racer-cruiser for Howard 'Smitty' Smith, owner of Ranger Fiberglass Boats of nearby Kent, WA. The boat is unusual in several ways. First, her topsides, though constructed of fiberglass, appear to be made of two panels of flat plywood bent to her sheer, giving her the look of hard-chine plywood vessel. Second, though only 24-feet long, her sales brochure says that her sizable galley can accommodate 'both a refrigerator and a gimballed range with oven.' (We doubt many boats sold had either convenience, especially the refrigerator, which would require frequent charging of the batteries.) Third, she has full flotation, rare in a boat this size. Best features: Her outboard motor well is placed on her centerline, forward of the rudder in the cockpit, giving good access to the helmsman and, because the prop wash immediately impacts the rudderblade, good control at slow speeds around dock or mooring. Worst features: That 'hard-chine' look will not appeal to everyone: it's not obvious why it is necessary."[3]

See also

[edit]

Similar sailboats

References

[edit]
  1. ^ a b c d e f McArthur, Bruce (2021). "Ranger 24 sailboat". sailboatdata.com. Archived from the original on 15 November 2021. Retrieved 15 November 2021.
  2. ^ McArthur, Bruce (2021). "Raymond Richards". sailboatdata.com. Archived from the original on 15 November 2021. Retrieved 15 November 2021.
  3. ^ a b c d e f g h i Henkel, Steve: The Sailor's Book of Small Cruising Sailboats, page 317. International Marine/McGraw-Hill, 2010. ISBN 978-0-07-163652-0