Surface plasmon

Surface plasmons (SPs) are coherent delocalized electron oscillations that exist at the interface between any two materials where the real part of the dielectric function changes sign across the interface (e.g. a metal-dielectric interface, such as a metal sheet in air). SPs have lower energy than bulk (or volume) plasmons which quantise the longitudinal electron oscillations about positive ion cores within the bulk of an electron gas (or plasma).

The charge motion in a surface plasmon always creates electromagnetic fields outside (as well as inside) the metal. The total excitation, including both the charge motion and associated electromagnetic field, is called either a surface plasmon polariton at a planar interface, or a localized surface plasmon for the closed surface of a small particle.

The existence of surface plasmons was first predicted in 1957 by Rufus Ritchie.^[1] In the following two decades, surface plasmons were extensively studied by many scientists, the foremost of whom were T. Turbadar in the 1950s and 1960s, and E. N. Economou, Heinz Raether, E. Kretschmann, and A. Otto in the 1960s and 1970s. Information transfer in nanoscale structures, similar to photonics, by means of surface plasmons, is referred to as plasmonics.^[2]

Surface plasmon polaritons can be excited by electrons^[3] or photons. In the case of photons, it cannot be done directly, but requires a prism, or a grating, or a defect on the metal surface.^[4]

At low frequency, an SPP approaches a Sommerfeld-Zenneck wave, where the dispersion relation (relation between frequency and wavevector) is the same as in free space. At a higher frequency, the dispersion relation bends over and reaches an asymptotic limit called the "plasma frequency"^[4] (see figure at right).^[a] For more details see surface plasmon polariton.

As an SPP propagates along the surface, it loses energy to the metal due to absorption. It can also lose energy due to scattering into free-space or into other directions. The electric field falls off evanescently perpendicular to the metal surface. At low frequencies, the SPP penetration depth into the metal is commonly approximated using the skin depth formula. In the dielectric, the field will fall off far more slowly. SPPs are very sensitive to slight perturbations within the skin depth and because of this, SPPs are often used to probe inhomogeneities of a surface.^[4] For more details, see surface plasmon polariton.

Condensed matter physics
Phases Phase transition QCP
States of matter Solid Liquid Gas Plasma Bose–Einstein condensate Bose gas Fermionic condensate Fermi gas Fermi liquid Supersolid Superfluidity Luttinger liquid Time crystal
Phase phenomena Order parameter Phase transition QCP
Electronic phases Electronic band structure Plasma Insulator Mott insulator Semiconductor Semimetal Conductor Superconductor Thermoelectric Piezoelectric Ferroelectric Topological insulator Spin gapless semiconductor
Electronic phenomena Quantum Hall effect Spin Hall effect Kondo effect
Magnetic phases Diamagnet Superdiamagnet Paramagnet Superparamagnet Ferromagnet Antiferromagnet Metamagnet Spin glass
Quasiparticles Phonon Exciton Plasmon Polariton Polaron Magnon Roton
Soft matter Amorphous solid Colloid Granular material Liquid crystal Polymer
Scientists Van der Waals Onnes von Laue Bragg Debye Bloch Onsager Mott Peierls Landau Luttinger Anderson Van Vleck Hubbard Shockley Bardeen Cooper Schrieffer Josephson Louis Néel Esaki Giaever Kohn Kadanoff Fisher Wilson von Klitzing Binnig Rohrer Bednorz Müller Laughlin Störmer Yang Tsui Abrikosov Ginzburg Leggett Parisi Wetterich Perdew
Physics portal  Category
v t e

Localized surface plasmons arise in small metallic objects, including nanoparticles. Since the translational invariance of the system is lost, a description in terms of wavevector, as in SPPs, can not be made. Also unlike the continuous dispersion relation in SPPs, electromagnetic modes of the particle are discretized.^[7]

LSPs can be excited directly through incident waves; efficient coupling to the LSP modes correspond to resonances and can be attributed to absorption and scattering, with increased local-field enhancements.^[7] LSP resonances largely depend on the shape of the particle; spherical particles can be studied analytically by Mie theory.^[4][7]

The excitation of surface plasmons is frequently used in an experimental technique known as surface plasmon resonance (SPR). In SPR, the maximum excitation of surface plasmons are detected by monitoring the reflected power from a prism coupler as a function of incident angle or wavelength. This technique can be used to observe nanometer changes in thickness, density fluctuations, or molecular absorption. Recent works have also shown that SPR can be used to measure the optical indexes of multi-layered systems, where ellipsometry failed to give a result.^[8][9]

Surface plasmon-based circuits have been proposed as a means of overcoming the size limitations of photonic circuits for use in high performance data processing nano devices.^[10]

The ability to dynamically control the plasmonic properties of materials in these nano-devices is key to their development. A new approach that uses plasmon-plasmon interactions has been demonstrated recently. Here the bulk plasmon resonance is induced or suppressed to manipulate the propagation of light.^[11] This approach has been shown to have a high potential for nanoscale light manipulation and the development of a fully CMOS-compatible electro-optical plasmonic modulator, said to be a future key component in chip-scale photonic circuits.^[12]

Some other surface effects such as surface-enhanced Raman scattering and surface-enhanced fluorescence are induced by surface plasmon of noble metals, therefore sensors based on surface plasmons were developed.^[13]

In surface second harmonic generation, the second harmonic signal is proportional to the square of the electric field. The electric field is stronger at the interface because of the surface plasmon resulting in a non-linear optical effect. This larger signal is often exploited to produce a stronger second harmonic signal.^[14]

The wavelength and intensity of the plasmon-related absorption and emission peaks are affected by molecular adsorption that can be used in molecular sensors. For example, a fully operational prototype device detecting casein in milk has been fabricated. The device is based on monitoring changes in plasmon-related absorption of light by a gold layer.^[15]

• Biosensor
• Dual-polarization interferometry
• Extraordinary optical transmission
• Free electron model
• Gap surface plasmon
• Heat-assisted magnetic recording
• Multi-parametric surface plasmon resonance
• Plasma oscillation
• Plasmonic lens
• Plasmonics (journal)
• Spinplasmonics
• Surface plasmon resonance microscopy
• Waves in plasmas